Application-focused selection guide for antimony trioxide (Sb2O3) masterbatch grades used in flame-retardant ABS appliance housings, enclosures, and structural plastic components requiring UL94 V-0 ratings.
Formulation & Processing Notes
- Carrier resin: ABS-dedicated masterbatch carrier with declared melt flow; matches the injection-molding grade resin to avoid weld-line weakening and flow marks in glossy housing surfaces.
- Halogen–antimony synergy: Maintain the near-3:1 molar Br:Sb ratio with brominated polystyrene (BPS) or decabromodiphenyl ethane (DBDPE) on the polymer fraction; typical 4–6 wt% Sb2O3 delivered from an 80% active masterbatch.
- Pre-drying: Dry masterbatch 80–90 °C for 2–4 h before molding; moisture causes silver streaks and splay on Class-A visible surfaces.
- Processing window: Monitor barrel temperature against brominated FR tolerance (<325 °C for DBDPE); screw back-pressure and fill speed affect white specks at knit lines.
- Quality checks: UL94 V-0 at 1.5 mm on molded plaques (not pressed samples), gloss uniformity, weld-line tensile retention, and impact retention versus unmodified ABS control per lot.
Supplier Qualification (CoA Verification)
- Purity ≥ 99.5%; moisture < 0.3%; D50 0.8–1.5 µm fine grade; Pb < 50 ppm, Fe < 100 ppm.
- Color consistency: whiteness deviation across lots within ±2% Lab b* — visible in light-gray housing colors.
- Request a per-lot retained sample and annual requalification for high-volume appliance programs.
Compliance
Sb2O3 content is declared per REACH hazard communication; confirm RoHS-relevant heavy-metal limits for consumer appliance end-use markets.