服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for POM (Acetal) Gears and Precision Components (Batch 117)

发布日期:2026-11-21 05:35:05   浏览量:0

Title: Sb2O3 masterbatch for POM gears and precision molded parts: thermal limits, crystal nucleation, and CoA verification

Polyoxymethylene (POM / acetal) gears, bearings, and precision molded components occasionally require flame retardancy for appliance, automotive-interior, and electrical-housing end uses. Antimony trioxide masterbatch is the standard halogen-synergy partner here, but POM is uniquely intolerant of acidic residues and processing abuse, so grade selection and QC discipline matter more than in almost any other engineering resin.

Formulation Guidance

  • Halogen source pairing. POM requires brominated FRs with high thermal stability and neutral/low acidity — brominated polystyrene or brominated epoxy oligomers are preferred over more acidic systems. Pair at the classic ~3:1 Br:Sb molar ratio; dose typically 3–5% Sb2O3 on the polymer fraction.
  • Acid sensitivity is the primary risk. Sb2O3 can react with acidic species to generate formic-acid traces and accelerate POM depolymerization (formaldehyde release). Choose high-purity, low-lead/low-iron grades and verify the halogen FR's thermal stability ceiling; if the FR degrades below POM's processing temperature, do not proceed.
  • Crystallization nucleation. Well-dispersed fine Sb2O3 (D50 0.8–1.5 µm) can nucleate POM crystallization — usually beneficial for gear dimensional stability, but verify crystallinity shift by DSC on trial parts, since excessive nucleation raises brittleness.
  • Carrier match. Use a POM-compatible carrier (POM-co or low-MFI polyacetal carrier) at 40–50% loading; mismatched carriers (olefin or EVA) cause delamination at gear teeth and loss of tooth strength.

Processing Checks

  • Temperature red line. POM processes at ~190–210 °C with a hard ceiling near 220 °C; Residence time must be minimized. Ensure every component (FR, masterbatch, lubricants) is stable below the POM decomposition onset — formaldehyde release is both a quality and a safety failure.
  • Gear-specific QC. Verify tooth strength (single-tooth bending), dimensional stability (crystallinity shift via DSC), and wear/noise on molded gears versus an unmodified control per lot.
  • Mold deposit watch. White deposits on mold surfaces during long runs signal plate-out; correct with lubricant balance and grade choice before approving the batch.

Supplier Qualification (CoA Verification per Lot)

  • Purity ≥ 99.5%; moisture < 0.3%; D50 0.8–1.5 µm (D97 declared); Pb < 50 ppm; Fe < 100 ppm.
  • Low-acidity grade confirmation — request acid number / pH data where the supplier can provide it, since acidity drives POM degradation.
  • Whiteness consistency within ±2% L* across lots for light-colored visible parts.
  • 200 g per-lot retained sample; annual requalification for high-volume gear and bearing programs.

Compliance

Confirm RoHS and REACH declarations per lot, and verify the final assembly meets the end-use market's flammability standard (e.g., UL94 V-0 at the specified thickness on molded parts, not PLA coupons).

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们