Focus: low-acidity grade selection, crystallization control and CoA verification for POM gear programs
POM (acetal) gears, bearings and precision molded parts used in appliances, automotive interior mechanisms and electrical housings sometimes require flame retardancy. Antimony trioxide masterbatch is the standard halogen-synergy partner, but POM is uniquely sensitive to acidic residues and processing abuse, so grade selection and QC discipline are critical.
Formulation Guidance
- Halogen source pairing. Use brominated FRs with high thermal stability and neutral/low acidity — brominated polystyrene or brominated epoxy oligomers are preferred over more acidic systems. Target the classic ~3:1 Br:Sb molar ratio; dose 3–5% Sb2O3 on the polymer fraction.
- Acid sensitivity is the primary risk. Sb2O3 in contact with acidic species can accelerate POM depolymerization (formaldehyde release). Select high-purity, low-lead/low-iron grades and confirm the halogen FR's thermal stability ceiling; if the FR degrades below POM's processing temperature, do not proceed.
- Crystallization nucleation. Well-dispersed fine Sb2O3 (D50 0.8–1.5 µm) can nucleate POM crystallization — usually beneficial for gear dimensional stability, but verify crystallinity shift by DSC on trial parts since excessive nucleation raises brittleness.
- Carrier match. Use a POM-compatible carrier (POM-co or low-MFI polyacetal) at 40–50% loading; mismatched olefin or EVA carriers cause delamination at gear teeth and loss of tooth strength.
Processing Checks
- Temperature red line. POM processes at ~190–210 °C with a hard ceiling near 220 °C; minimize residence time. Every component (FR, masterbatch, lubricant) must be stable below POM's decomposition onset — formaldehyde release is both a quality and a safety failure.
- Gear-specific QC. Verify tooth strength (single-tooth bending), dimensional stability (crystallinity shift via DSC) and wear/noise on molded gears against an unmodified control per lot.
- Mold deposit watch. White deposits on mold surfaces during long runs signal plate-out; correct via lubricant balance and grade choice before batch approval.
Supplier Qualification (CoA Verification per Lot)
- Purity ≥ 99.5%; moisture < 0.3%; D50 0.8–1.5 µm (D97 declared); Pb < 50 ppm; Fe < 100 ppm.
- Low-acidity grade confirmation — request acid number / pH data where available, since acidity drives POM degradation.
- Whiteness consistency within ±2% L* across lots for light-colored visible parts.
- 200 g per-lot retained sample; annual requalification for high-volume gear and bearing programs.
Compliance
Confirm RoHS and REACH declarations per lot, and verify the final assembly meets the end-use market's flammability standard (e.g., UL94 V-0 at the specified thickness on molded parts).