服务热线
18971017202
For rubber conveyor belt cover compounds and rubber liners, antimony trioxide (Sb2O3) is normally supplied as a masterbatch pre-dispersed in an elastomer-compatible carrier rather than as dry powder, because Sb2O3 is hard to disperse in high-viscosity rubber and poor dispersion shows up as white bloom, under-cured spots and variable flame performance.
Carrier selection should follow the base polymer: masterbatches on SBR/BR or EPDM carriers suit NR/SBR and EPDM belt covers, while EPDM or NBR carriers suit NBR/EPDM blends. Confirm the declared carrier polymer and Mooney viscosity with the supplier, and avoid silicone-compatible grades in sulfur-cured belts unless the cure system has been revalidated, since peroxide systems can interfere with peroxide cures.
Dose guidance: target Sb2O3 about 3-6 phr against the polymer fraction, paired with a halogen source at a molar Br:Cl:Sb ratio near 3:1; chlorinated paraffins (CP-52/70) or brominated additives are common partners in belt covers. Zinc borate 3-8 phr is frequently added for smoke and afterglow suppression, and the halogen/Sb ratio should be retuned when borate is introduced.
Processing points: pre-warm and pre-dry the masterbatch after storage above 60% relative humidity; keep dump temperatures within the supplier's stated window to avoid bloom; check two-roll mill dispersion (no visible white specks at 5x) plus ash uniformity within ±10% across the batch.
Acceptance and qualification: require a CoA per lot with purity ≥99.5%, moisture <0.3%, D50 0.8-1.5 µm, Pb and Fe at declared limits; qualify each lot by LOI and vertical burn on cured cover slabs (not on raw stock), plus hardness, tensile and compression-set checks after aging, and drum-friction or ISO 340 flame-propagation testing on finished belt specimens for mine-service belts. Retain a 200 g sample from each lot for 12 months and requalify the grade annually.