服务热线
18971017202
ASA and ASA/PC blends are chosen for weatherable enclosures, outdoor equipment housings, and automotive exterior trim; adding Sb2O3 masterbatch to these resins requires balancing flame retardancy with the weatherability that motivated the resin choice.
Formulation notes - ASA is styrenic, so brominated co-additives work at Br:Sb ≈ 3:1 on the polymer fraction; brominated epoxy oligomers or brominated SBS with good thermal stability are preferred because ASA compounding sits near 230–250 °C. - Carrier should be ASA or SMA-compatible with matched MFI (within ~15%); a SAN carrier is acceptable for ASA but can haze UV-stabilized blends. - Keep UV absorbers and HALS in the package — Sb2O3 does not replace them, and heavy filler loading can accelerate chalking if UV protection is reduced to pay for FR content. - Dose window: 3–5 wt% Sb2O3 effective for typical V-2/V-0 targets on 1.5–3 mm sections, retuned upward when glass or mineral fill is present.
Processing & QC checks - Pre-dry pellets (80–90 °C, 3–4 h) if stored above 60% RH — ASA absorbs moisture slowly but blisters at high melt temperatures. - Monitor die and mold for white bloom over long runs; fine D50 0.8–1.5 µm grades minimize gloss loss and bloom on textured exterior surfaces. - Verify color hold and ΔE after QUV/xenon exposure — flame-retardant ASA must weather as well as the unfilled control. - CoA hard checks: purity ≥99.5%, moisture <0.3%, Pb <50 ppm, Fe <100 ppm; trial-mold a plaque and compare gloss/impact vs. unfilled control.
Qualification & traceability - Confirm reaction-to-fire class (EN 13501-1 or UL94) on the final part geometry and thickness. - 200 g retained sample per lot, 12 months, tied to the housing part batch number so field complaints trace without rework. - Annual supplier audit covering dispersion aids and particle-size consistency — outdoor-grade parts cannot tolerate lot-to-lot color drift.