服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Rigid PVC Profile Extrusion: Carrier Selection & Process Checks

发布日期:2026-11-21 05:35:22   浏览量:0

1. Carrier selection

  • Match carrier polymer to the base rigid PVC grade: a rigid-PVC (K-value ~58-65) carrier is preferred over plasticized carriers to avoid plasticizer migration and bloom in profiles.
  • If an EVA/CPE impact modifier blend is used in the base, choose a carrier of similar polarity for even Sb2O3 distribution.

2. Dosing & halogen-antimony synergy

  • Typical Sb2O3 loading 3-5 phr on the formulation; for wall panels and wainscoting with softening surface layers, reduce to 1-2 phr in the cap layer to limit surface plate-out.
  • Retain ~3:1 Cl:Sb ratio when the halogen source is chlorinated paraffin (CP-52/70) or PVC's own chlorine backbone; retune to ~3:1 Br:Sb when brominated flame retardants are co-added.

3. Fine-grade particle size

  • Use fine-grade Sb2O3 (D50 0.8-1.5 µm) to control white specks and surface bloom on smooth profile surfaces and embossed textures.
  • Verify CoA for purity ≥99.5%, moisture <0.3%, Pb <50 ppm, and whiteness consistency between lots.

4. Process checks

  • Keep melt temperature ≤190 °C and monitor die/calibration-plate plate-out during extrusion; a pressure-rise or die-build-up signal indicates overdosing or poor dispersion.
  • Pre-dry the masterbatch (2-4 h at 80 °C) if stored above 60% RH to avoid steam streaking and splay.

5. Trial qualification

  • Run a trial extrusion and check gloss, embossing fidelity, impact, and heat-stability (two-roll mill 10-15% torque-drop red line). Confirm reaction-to-fire rating at the target wall thickness.
  • Retain 200 g per lot for 12 months for batch traceability.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们