Scope
Flame-retardant Sb2O3 masterbatch for PVC artificial leather and coated fabrics used in upholstery, automotive interior trim, tarpaulins and protective clothing.
Formulation & Carrier
- Carrier: plastisol-compatible or flexible-PVC carrier with a declared plasticizer content (DOP/DINP) so that dose stays predictable on the coating line.
- Ratio: maintain Cl:Sb ≈ 3:1 against the chlorine source (chlorinated paraffin CP-52/70) or brominated FRs when blended.
- Dose: typically 4–6 phr on the PVC compound; reduce when the substrate already carries a bromine source.
Key Risks to Watch
- White specks / surface bloom on thin 0.2–0.5 mm coatings — use a fine grade D50 0.8–1.5 µm.
- Plasticizer migration & blooming during warm storage: may present as surface whitening over weeks.
- Plate-out on coating knives / calender rolls — watch melt temperature and pre-dry before use.
Process Checks
- Pre-dry when storage >60% RH.
- Run a line trial on 200 g per lot before batch commit; monitor coating gloss, adhesion and speck count.
- Validate LOI / vertical burn on the finished coated fabric, not the masterbatch alone.
QC / CoA Verification
- Purity ≥99.5%, moisture <0.3%, Pb <50 ppm, Fe <100 ppm, whiteness consistency across lots.
- Film-level checks: tensile, adhesion, cold-crack, wash/abrasion resistance.
- Retained sample 200 g / 12 months per lot for traceability.
Supplier Checklist
- Confirm carrier resin & plasticizer declaration on the CoA.
- Request D50/D97 and dispersion evidence for the specific coating process.
- Annual re-qualification and per-lot retained-sample agreement.