服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for XPE/IXPE Crosslinked Polyethylene Foam Insulation

发布日期:2026-11-21 05:35:23   浏览量:0

Carrier & Base Resin Matching

  • XPE/IXPE foam starts from a low-density polyethylene (LDPE/LLDPE) base with a blowing agent (usually azodicarbonamide, ADC) and a chemical crosslinker (peroxide or silane).
  • Use an LDPE/LLDPE masterbatch carrier whose MFI sits within 10–15% of the base resin to avoid crosslink-density drift and melt-flow mismatch on the extrusion line.
  • Confirm the carrier is peroxide-tolerant: some carriers contain stabilizers that scavenge the free-radical initiator and suppress crosslinking — verify gel content against a powder-blend reference.

Dose & Halogen–Antimony Synergy

  • Target Sb2O3 loading 2.5–4 wt% on the resin fraction, with a ~3:1 Br:Sb or Cl:Sb molar ratio vs the halogen co-additive (DBDPE, brominated epoxy oligomer, or chlorinated paraffin).
  • For low-smoke formulations add zinc borate at 30–50% of the Sb2O3 dose; keep total additive loading below the point where cell structure collapses (foam density 25–90 kg/m³ target window).
  • Retune the dose when switching from loose powder to masterbatch — typically reduce by 10–15% because masterbatch dispersion is more uniform.

Dispersion & Processing Checks

  • Crosslinked foam is sensitive to undispersed Sb2O3 agglomerates, which act as cell-wall puncture sites and cause local over-foaming or surface pits.
  • Fine-grade D50 0.8–1.5 µm recommended; pre-dry the masterbatch 2–4 h at 80 °C when storage humidity >60% RH.
  • Watch melt temperature during extrusion (≤200 °C for peroxide systems) and monitor for early blowing-agent activation or die face build-up (plate-out) indicating overheating.

Qualification & QC

  • Verify per-lot CoA: purity ≥99.5%, moisture <0.3%, D50/D97 particle size, Pb <50 ppm, Fe <100 ppm.
  • Run a lab foam sheet trial per lot: gel content (ASTM D2765) within spec, foam density ±10% of target, cell uniformity visual check, and UL94 / reaction-to-fire at the final board thickness.
  • Keep a 200 g per-lot retained sample for 12 months for traceability and dispute arbitration.

Supplier Selection Notes

  • Prefer suppliers who can demonstrate a consistent CoA history and offer fine-grade Sb2O3 with tight D50/D97 control, since foam properties are directly sensitive to particle-size consistency.
在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们