服务热线:
18971017202
您的位置:首页 >> 新闻中心

Sb2O3 Masterbatch for Expanded Polypropylene (EPP) Foam Molded Parts

发布日期:2026-11-21 05:35:24   浏览量:0

Application Context

EPP (expanded polypropylene) foam molded parts are widely used in automotive bumpers, interior door panels, seating cores, and protective packaging. Flame retardancy is increasingly specified for vehicle-interior and building-related EPP components.

Key Formulation Points

  • Carrier matching: EPP bead foaming demands a low-melt-flow, EVA or PP-based carrier that survives steam chest molding; carrier MFI should sit within ~10–15% of the base PP resin to avoid bead-to-bead segregation.
  • Halogen-antimony ratio: Retune Br:Sb to ≈3:1 on the effective bromine fraction when pairing with brominated flame retardants (e.g. decabromodiphenyl ethane); with chlorinated sources, use Cl:Sb ≈3:1 and re-dose for chlorine content.
  • Dose window: Sb2O3 at 3–5 wt% on the polymer fraction is a common start; verify against the target reaction-to-fire class at final molded density, not bead stage.
  • Fine particle size: Use fine grades (D50 0.8–1.5 µm) to prevent bead-surface whitening and to minimize interference with cell-wall integrity during expansion.

Processing & QC Checks

  • Steam chest molding: Monitor for additive migration/plate-out onto mold surfaces across repeated cycles; clean schedule should be documented.
  • Cell structure: Compare molded density and cell uniformity (±10%) against control to catch nucleation interference from the masterbatch.
  • Moisture control: Pre-dry the masterbatch 2–4 h at 80 °C when stored above 60% RH to avoid voids/surface defects in steam expansion.
  • Trial QC: Run LOI / vertical-burn on finished molded plaques (not beads), plus a dimensional and surface-finish check before committing a batch.

CoA Verification Checklist

  • Purity ≥ 99.5%, moisture < 0.3%, Pb < 50 ppm, Fe < 100 ppm
  • Particle size D50 / D97 within declared range; whiteness consistency across lots
  • Antimony content assay matching the masterbatch dosing claim
  • Per-lot retained sample of 200 g kept for 12 months for dispute arbitration

Bottom Line

Select the masterbatch for EPP steam-molded parts by matching carrier MFI, retuning the halogen:Sb ratio on effective halogen, and qualifying at final molded density — with fine grades and strict moisture handling to protect cell structure and surface quality.

在线咨询 联系方式 二维码

服务热线

18971017202

扫一扫,关注我们